Chev 350 HEI to leyland 4.4l

[mark4130]

Ive recently converted the Chev 350HEI distributor to fit the leyland 4.4l.

To my suprise it was an easy modification and well worth it.

Basically i purchased the chev dizzy and removed everything off it(left me with just the housing)then done the same to the original 4.4l dizzy.I then cut the 4.4l dizzy approx 2 in above the locking clamp,measured it up against the chev dizzy so i could use the chev shaft and cut the base off the chev dizzy.(this is becoming confusing)Then had it welded together,redrilled the pin hole to fit the 4.4l drive gear cog.
Installed it and walah she started first time and she purred.:waycool:
(well after a quick tune)

Thats pretty much it

Mark.http://i96.photobucket.com/albums/l174/markh4130/22march2007035.jpg

[Rocky4.4]

Well done Mark, Done a great job bet she goes Heaps better now.:D

[bruggz351]

bloody hell!! top job mate. you make it seem like such a simple mod. looks tops, love that clear cap:D:D

[mark4130]

how cool is the clear dizzy cap:waycool:
yeah it sold me;)

Well done Mark, Done a great job bet she goes Heaps better now.

heaps better aint word for it,no more fiddling around with points,set and forget.

bloody hell!! top job mate. you make it seem like such a simple mod. looks tops, love that clear cap

yeah a lot simpler than thought going into it,the hardest part was cutting up the brand new dizzy,no turning back!:D

Thanks guys i hope it inspires others to do the same.Its well worth it:thumb:

Mark.

[101 Ron]

The Yanks have been doing it for years on rover V8s......chev dist to fit rover as the chev parts are easy to get over there.