BMS
01-09-2007, 03:36 PM
For those that reckon the ML seats are rubbish like myself I
have found what might be a good temporary fix.
If you look at the back of the seats you'll notice the seams down
each edge of the back rests are actually zippers so if you pull the
tails out from the bottom you can undo them and get into the back
of them.
What I have done is to shape a piece of high density surfboard foam
and run a groove along the back of it so it stays in place on the lower
metal bar in seat where they lack support.
This fills out where the small of your back rests.
Hey PRESTO it is defiantly an improvement.
Hope this helps bms
have found what might be a good temporary fix.
If you look at the back of the seats you'll notice the seams down
each edge of the back rests are actually zippers so if you pull the
tails out from the bottom you can undo them and get into the back
of them.
What I have done is to shape a piece of high density surfboard foam
and run a groove along the back of it so it stays in place on the lower
metal bar in seat where they lack support.
This fills out where the small of your back rests.
Hey PRESTO it is defiantly an improvement.
Hope this helps bms