lifting old pajero?

[Z L]

hey evryone i just wanna know if its possible to put the rear diff under the springs on my 85 pajero to give it more height andif i can hoe can i lift the front end to match the heght of the rear thanks.

[MadPaj]

what your thinking about is a spring over axel (SOA) it will give you the lift of the hight of ya diff housing thing about (4-5inches)

coversion, they back might be fine- if you do it youll need to think of length of handbrake cable, longer shocks and breaklines


HOWEVER- youll NEVER get the front to sit as high EVER, the MOSt you can ask is 2-3inches if you wind the bejesus outta the front tosion bars, ball joint spacers and the like may get you a inch but your just going to make the car nigh impossible to drive by screwing with the front(steering ) end so much


also think of the extreme angle your cv's will be on, the greater the angle= quicker they will breack



the best(reliable and safest) way would be a 2inch lift springs, wind the front torsion bars to match(maybe go heavy duty ) put a 2 inch body lift and put 33's on it

then it will be a HEAP higher, it will be almost the same to drive (may need to change gearing in transfer/diffs to get your lowrange back) and your less likely to break stuff

[Z L]

sweet thanks for the advicw madpaj

[Z L]

wat about S.A.S ?

[StevenB]

have a look on outerlimits and 4x4wire in the mitsubishi section, there are a few that have done it